Check and prepare the area
Repair uneven surfaces and clean the installation area before work begins.
Installation Guide
A considered process.
A better finish.
Seven installation stages from the Armstrong catalogue, with original technical diagrams for closer review.
Lucky5 Corporation · PhilippinesTHE INSTALLATION PROCESS
Seven steps. One coordinated system.
Wall positioning
Use a leveling device to set out the wall position and check alignment.
Prepare adhesive
Prepare the specified cement adhesive and apply it to the foundation as directed.
Size and cut panels
Cut panels to the dimensions required by the approved layout using appropriate equipment and safe working procedures.
Install panels
Position panels upright, apply adhesive at joints, align with a claw bar and temporarily support with wedges. Use only manufacturer-approved and engineer-approved fixing details.
Grouting
Apply the specified grout to the panel joints in accordance with the approved installation instructions.
Cleaning and finishing
Remove excess grout with a scraper before it dries, then prepare the surface for the specified finish.
Coordinate tools and materials
The catalogue illustrates cutting and drilling equipment, a claw bar, wedges, a cement trowel, adhesive, grout and reinforcement. Confirm the complete equipment, handling and safety plan with the installation team.
TECHNICAL REFERENCE
A closer look at the connections.
Select any diagram to enlarge. Original artwork is reproduced from the 2025 reference catalogue; current fixing details require confirmation.
Original labels are retained for reference. These are typical details, not project-specific engineering drawings. The 2027 catalogue repeats these detail types; confirm reinforcement, anchorage and joint requirements before use.
LET’S BUILD SOMETHING BETTER
Your next project.
Our next conversation.
Talk to Lucky5 about the right wall panel solution for your plans.